Jump to content

Hard starting NEW MEMBER


Mccabe87

Recommended Posts

  • Platinum Member

Hi guys back again after replacing all injector seals I have ran I to a major starting problem.

Jeep turns over and does not fire up. Checked cam sensor and wiring and all is good with that.

I do have a video of it turning over and a video of one of the fuel lines with loads of big air bubbles in it and small ones that seem to foam up. It's the one that goes to the low pressure pump along the rail.

I am going to try easy start tomorrow but I need to address the problem obviously so just asking here for advice beforehand.

Have ordered an ELM327 device and also downloaded jeepdiag to see if that clears the codes which are p0340 p0540 p1685 and p0702

Thanks.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

guidelines